FEATURES:   This aftermarket mount was designed to address many of the deficiencies found in the older generation M1A mounts Fits Mil Spec Springfield M1A Rifles including Scout Squad New Generation Design with a Secure Two point locking system to provide a stable platform for your optics Low profile Picatinny Top Rail with with see through channel, allows use of iron sights Will not fit Socom II Allows for mounting your optics in a low ergonomic position on your rifle Note that installation of this mount will require minor fitting on your rifle Installation requires removal the rear stripper clip guide on your rifle by drifting out a pin Minor filling to the mounting bracket of the scope mount may be required to achieve a custom fit Includes detailed written installation instructions SPECIFICATIONS:   Length: 6.25" Material: Aluminum Color: Anodized Matte Black Imported   Brand New With Manufacture Warranty ____________________________________  

FEATURES Made by Springfield ArmoryMaterial: AluminumColor: Matte black This original Springfield Armory brand scope mount uses two bolts to fasten the mount to your rifle thus providing a secure mounting platform for your optics. Center section is cut out to facilitate case ejection and provides better access to the rifles chamber for clearing malfunctions. Installation requires removal of your rifles stripper clip guide and replacing it with an included part that accepts the rear bolt on the scope mount. The front bolt then attaches directly to the pre-existing hole on the left side of your rifles receiver. Due to the varying manufacturing tolerances on a series of rifles that have been produced over the past 40 years, some minor fitting may be required to the mount. Does not require drilling holes in your receiver. Fits most Springfield M1A, M14 and similar clones including Norinco M14 rifles. Does not fit SOCOM II M1A rifles because the factory rail system on those rifles will...